Subject: It;s alive the slide throttle P-port engine
From: Rotary Engine
Date: 6/3/2005, 10:02 PM
To: AA-me



    BTW your comments on the return flow getting hot is very pertinent
    to what we are going through on fuel systems. Got any data on
    return flow fuel heat?

No hard data, sorry. At idle, there is a lot of recirculation, so the
fuel can pick up a lot of heat from the pump and pipe friction. At
power, there is less recirculation, but the whole environment might be
hotter. It would therefore seem to be somewhat application dependent, as
well as dependent on ambient conditions, and of course dependent on how
much fuel there is in the tank.
Jon

We were measuring it yesterday but we did not run long enough
for anything meaningful. Dave was smart. He put the return
flow sensor ahead of the pressure regulator. It now seems to
be very stable.

Paul Lamar

I have worked  on this problem as I had time this week.  I just vacated
my office and my books are packed in boxes stacked everywhere.  I
haven't been able to find a number for the convective heat transfer
coefficient for a horizontal pipe in air.  Can anyone help me out on
this one?   Of course, it will be difficult to calculate this exactly
without measurements from a specific system.  But, I think I can get a
reasonable estimate that will shed light on whether temperature rise in
the return container, whether it is a sump or the main tank, is a
serious issue.

Aubrey Thompson

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.