We are finding it a bit difficult to set the mixture using
Tracy's computer on the dyno. In an aircraft at low altitude there is
a much simpler set of situations where intake manifold pressure
is strictly a function of throttle opening. On a dyno
the load can be varied over a wide range. Tracy's in the air method
of setting the map works quite well but it is less well suited
to a dyno situation.

Never the less we got one useful data point where the throttle
was 3/4 open at 5250 and intake air temp of 84 degrees F.
The HP was 148. BSFC was .53 and EGTs were 1402 and 1477.
EGTs were down about 100 F from peak 1532 and 1580
The air:fuel mixture was about 15:1
Unfortunately the mixture knob was set to full rich at that point.
We were using the default mixture settings.

Frankly I am not entirely sure what we are going to do next.

Paul Lamar

Aren't you going to start bumping up the injector map settings?  It
makes sense that the default settings are too lean for a PP right?

I think many of us are waiting eagerly for results.  Keep up the good
work Paul.

Hans

Well Dave Lemon is getting a bit apprehensive. He has not been paid
yet. This engine is easily capable of destroying itself if it is not
properly loaded at high RPM. Mixture could go very lean at 12,000 RPM
or higher. He is rightly concerned. Most of his dyno experience has
been with carbs that usually provide a near usable mixture setting
throughout the power band. Also carbs tend to have a moderate throat
size to provide a good fuel signal at the low end. This tends to limit
HP and RPM at the top end compared of course to say; a p-port with a slide
throttle. In an airplane the load is always there. The prop runs
into a load brick wall around 2700 RPM which of course limits the
engine RPM to 2.85 times that or 7700 RPM.

I am debating with myself if we should move the engine to a prop
dyno which is more suitable for setting the mixture using Tracy's
programming methods.

Paul Lamar

Can't he program the dyno to have a load curve with respect to rpm that
mimics a prop load curve?
Bill Schertz
KIS Cruiser # 4045

I don't think this dyno is that sophisticated. I am not sure
as I have not read the dyno manual. I'll ask. There is a big
hand crank on the left that sets the load.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.