I fly a Zenair Zenith 200 with a l986 13B. I have installed a
Cyberdyne Instruments bar graph air/fuel gauge (P/N 7009). The O2
sensor
is located ~31 inches from the exhaust ports. The O2 sensor is not a
Cyberdyne Instruments part. It is an aftermarket universal single wire
sensor. The readings of the air/fuel gauge are baffling me. At idle of
1100 rpm and MP of 14.1-14.2 inches/mercury, the air/fuel gauge shows
a
rich condition of ~12.7:1. That is where the engine runs best at idle.
At full power static of 5200-5250 rpm and MP of ambient (~30
inches/mercury), the air/fuel gauge reads rich ~13.2:1. However, when
I
retard the throttle to 3000-3500 rpm, at a MP of 17.0-17.1
inches/mercury, then the air/fuel gauge reads lean at ~16.0:1. The
engine runs quite evenly at all power settings but I wonder if the
variations in fuel mixture are normal and safe?
Yvon.
Kind of typical when you pull back the throttle as the
fuel is mostly shut off. Those kinds of instruments work
best under steady conditions. Are you using a carb Yvon?
Paul Lamar
Hi Paul, Following the testing of your PP engine with great interest...
Will we ever know about Paul Conner's accident?
When I first flew my Rotary powered Zenith, it was with a GM-Rochester
two barrels carburetor. It flew safely, but when I became aware of
Holley fuel injection I installed a Holley Pro-Jection two barrels fuel
injection system. Still using my original homemade intake system.
Yvon.
As soon as the final report is published by the NTSB I can give
a report of my findings.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.