Hi guys,
Sorry to inject a newbie question into this fascinating discussion, but I am
building a single place gyro and wish to power it with a single-rotor
Renesis.  The airframe is designed for a Rotax 503, and in this
configuration will accommodate a 66" prop.  Does anyone know where I can
find drawings of the Renesis engine, so that I can work out the geometry of
the engine mount and redrive offset in order to swing a 68" prop?  Also, any
info re: CG of the Renesis would be helpful.

Regards,
Duncan of Devonport
Auckland
New Zealand

Duncan,

Nice place to live Devenport!

Are you sure this is doable? Isn't the Rotax 503 something below half
the weight of a 6.5B (a single rotor based on a mzda). I would have
thought you would need to go for a Diamond rotary to be in the right
weight category?

Mark from Taupo (now in Vienna)

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.