Subject: Renesis Exhaust injector table website add
From: Rotary Engine
Date: 6/7/2005, 7:34 PM
To: AA-me


Hi everyone,

has anyone seen any difference between the Renesis 4-port and the 6-port
engine on the exhaust side?

Dimensions of the ducts, position, etc.


Thomas J.

Hi Tomas,
I posted a dwg last week of all the ports for the six port Renesis.
Regards Don

I was not able to read that dwg Don. This is all I have.
Can you send an IGES or DXF both zipped?

Paul Lamar





Hi Paul,
 Sorry about that I thought that you received it ok. I have attached a
2000 Acad dwg that I have zipped as I know they dont travel well.
Paul I had the Renesis injectors flow tested today trying to get a
handle on how the computer controlled the power output. I am looking to
use the two red injectors that as direct injection int the center
housing. and run two injectors in the outer housing runner where I have
made common in the last 2.5". I have figures on the injectors.
Yellow injector flowed 46.8 cc with a  2.5 M/Sec  pulse width for one
minute.
Red injector flowed 37.5 cc with a 2.5 M/Sec pulse width for one minute.
My question is what M/Sec is the best for our aircraft operation to
achieve a good BSCF. I will attached information from a web page but
this does not give any pulse width.
Paul what are your thoughts on this.
Regards Don
*Nippon Denso*




Don. That injector table is a mess. Please send it again
as an attachament.

Paul Lamar



Don Dunbar Wrote.
Paul try this link to the injector page.
The 1990 turbo injector was supposed to out put 550cc. This injector was
also in the  MX6 4 cylinder turbo.
http://users.erols.com/srweiss/tableifc.htm#BOSCH

Regards Don


-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.