Subject: Very strange problem after installing new turbo
From: Rotary Engine
Date: 6/9/2005, 3:49 PM
To: AA-me


   Dave Leonard wrote:
   [snip]
    > My initial thoughts were:
    > the new intake I installed had come undone
   [snip]
    > Several Ground runs yielded the following info:
    > Engine ran normally up to about 35" MAP when the RPM dropped again to
    > 4700 (from 5100).  _MAP was still showing 35"_ measured at the engine
    > block. This pretty much rules out surge or intake problems.
    > As I backed down the MAP to about 28" it would 'catch' again the the
   RPM
    > would go back up to where it should be.  Increase the throttle again
    > and somewhere between 31" and 35" the RPM will suddenly drop.
    > (Have run up to 45" MAP with the old turbo without any such problems)
    >
    > Turning to full rich increases the RPM slightly but does not make it
    > normal.

   Since an intake leak would enrich the mixture, and since the "problem"
   seems to be reduced when you enrich the mixture manually, I'd say that
   confirms the premise that you don't have an intake leak problem.

    > Fuel flow and fuel pressure remain normal.

   I was thinking you were exceeding the fuel pump's ability to keep the
   rail pressurized appropriately (think "carb float bowl empty" behavior).
   This would seem to jive with the symptoms (things are normal until you
   reach "high consumption" state and then whammo! engine goes lean).  But
   constant fuel pressure measurement would seem to contradict this
   premise.

   Perhaps you have a problem with the staged injectors?  This would seem
   to fit with the throttle position behavior (comes & goes with throttle
   position).  Perhaps the EFI computer has the wrong setting for them
   (wrong rate, wrong duration), the wiring has a fault (insufficient
   current), the injector's fuel supply is compromised (fuel rail defect,
   o-ring mis-seated), or the injector is fouled (particulate obstruction,
   gumming)?

   I'm with Paul: see if you can measure mixture in the *exhaust* (use an
   O2 sensor and unleaded gas).  Since we seem to have ruled out air intake
   problems, measuring mixture will give an indication if fuel delivery is
   the problem.

Possibly an ignition problem -- a weak ignition (secondary side) will
show up under higher load and with a leaner mixture. Check spark plugs,
make sure ignition wires are OK and not arcing, if there is a cap and
rotor in the system they are likely culprits.  Also (hate to suggest
this...) check the compression.
Jon

-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.