> Excellent pattern making and casting. Very light
weight for a sand
> casting.Designed to fit the four and six port 2nd
gen Mazda
> engines. Should work
> on a six port RX8 engine with modifications. An
easy 200 HP at
> 7500 RPM with a 2.85:1 gear box.
> > Contact Francois for a price.
> >
http://www.mistral-engines.com/
> > Look for their booth and Wankel engine powered
Piper at OSH
> > --------------------------------------
> > I forgot to mention a very nice feature of this
manifold.
> Since the injectors are on the hot side Mistral
designed into
> the lower part of the manifold a way of adding a
stainless
> steel sheet metal box to enclose the injectors and
shielded them
> from exhaust manifold heat. It also catches any
leaking fuel
> and carries it away safely. Notice the small slots
cast into
> and machined in the lower section of the manifold.
These
> slots are designed to accept the SS sheet metal.
> Very professionally done. Excellent design.
> > Paul Lamar
This does look like very nice work. I'll need (at
least) a lower intake manifold for a 6-port Renesis
engine.
Are the benefits and risks of having the injectors
on this side of the engine worthwhile for a non-PP
engine?
Scott Gettings
Paul, did you post pictures of the new manifold?
I didn't see any. Thanks,
Bill Jepson
It because you are on AOL Bill. You need to get off AOL.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.