Subject: New intake manifold from Mistral
From: Rotary Engine
Date: 6/23/2005, 1:05 AM
To: AA-me


Paul,
I doubt very much that's a sand casting, I'm not doubting that you were
told
it was a sand casting. I might however be done in a low pressure cast iron
mold.
This is what I was looking at for the bellhousing.
George (down under)

No it is a sand casting George. You can tell by the surface roughness in
the inside. In fact Francois is thinking about some sort of internal
finishing
such as the Extrude Hone process. The outside have been smoothed somehow
or merely powder coated paint thereby smoothing the surface finish.

Paul Lamar

Fair enough Paul, it is however a nice looking product.
George ( down under)




-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.