Subject: Two cycle oil in the sump.
From: Rotary Engine
Date: 6/27/2005, 6:31 PM
To: AA-me


        I looked into this some time ago, and concluded that two stroke
   oils are
        not suitable for the sump. From memory, the reasons were:
        1. The viscosity is not sufficient to maintain proper film
   thickness in
        journal bearings.

        2. The oil is formulated with a carrier that is designed to promote
        mixing with gasoline. The carrier itself detracts from the
   properties of
        the fluid as a lubricant if it is used neat.

        3. The flash point of bulk two stroke oil is dangerously low.

        I would think that a suitable lubricant could be formulated to
   address
        these issues based on two stroke oil technology, but there
   would have to
        be significant financial incentive for an oil company to do so.
   Perhaps
        the Idemitsu oil is essentially what we are talking about,
   although as I
        recall the Idemitsu oil carries API SF or higher ratings which
   would
        suggest that the formulation is more similar to a typical
   automotive
        oil.

        Jon

   Thanks for the good info, however I still have some concerns with
   synthetics as they are known to mobilise lead deposits in engines that
   have been run on leaded fuels leading to obstruction of small oilways. I
   actually saw this happen to an O200 engined aircraft fairly recently, I
   think the synthetic involved was Mobil 1, to which the owner had
   recently changed, the engine lost compression due to the hydraulic
   tappets becoming blocked with the deposits.

   It would be nice to have specific information to allow direct comparison
   of film strength, but I guess oil companies revealing that would not be
   seen as in the corporate interest!

   I have to confess to being something of a sceptic, who could tell if the
   Idemitsu Rotary Engine Oil was 2 stroke oil repackaged? Most of us will
   believe just about anything if it's released with enough hype!
   When I was talking to the various oil company technical people they just
   kept referring to viscosity when I asked about film strength, presumably
   they regard them as the same thing.
   When you look at ATF it is obviously less viscous than engine oil, now I
   know that a few years ago one of the tricks used by
   motorcycle Production Racers was to use ATF in the sump, apparently its
   lower viscosity gave them a few more rpm than more viscous oils. There
   is no evidence that it was in any way harmful.
   John Evans

   Synthetic oils do not appear to be a problem in rotaries.
   I have been using Mobil One for five years in my RX7 and RX8.
   Lately Idemitsu rotary engine oil in the RX8.
   Tracy Crook has been using Mobile One in his rotary powered RV4 aircraft
   for several years. Tracy uses high lead 100 LL aviation fuel from
   time to time as auto fuel is not always available at airports.

   Paul Lamar

Obviously I accept that Mobil 1 is OK in new or comprehensively
reconditioned and  cleaned engines getting the odd thankful of leaded
fuel, but I remain sceptical as to the wisdom of its use where those
lead deposits may be mobilised.
John Evans.


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.