We ran the p-port engine again today on the EFI system
and slide throttle. Runs great. Will idle below 1000 RPM.
Starts easily. Idles smoothly more or less under 1500 RPM.
The mixture through out the RPM range is better with
the $200 manifold referenced fuel pressure regulator
but still a bit rich on the low end and a lean on the
high end. We are running out of dyno time to do further
mixture and ignition timing tuning. Max HP was 222. I used
Tracy's Mode three to set the mixture richer by eight clicks
over the entire MAP and RPM range. We did no Mode 1 tuning.
From here on out final tuning will be done with a prop
load in the air at altitude. The EGT's track together within about
40 F which Dave says is not that bad. Could be a
difference in fuel injectors. Perhaps one runner at
the slide throttle is leaking more air than the other.
No time to build a new sealed slide throttle before Dave must
dyno another engine. We will do one more run tomorrow or the
next day with Jerry's muffler.
Next project is to bench test some fuel injectors.
Paul Lamar
Paul,
I think the results will only get better with some minor tweaking.
George (down under)
I hope so. I just revised the design yet again to eliminate
all possibilities of air leaks affecting the tuning.
More about that later.
Paul Lamar
Paul, these are excellent results. Congratulations!! You have now
proved that the remote injectors work. That is a big deal. As far as
I am concerned cool side fuel (at least for p ports) just went from a
dream to a reality. Sooner or later cool side fuel will save someone's
life.
I am glad to hear you are going to test the muffler while on the dyno.
I got my fingers crossed. Jerry
BTW we are dropping all people on AOL in one week. We are still
getting too many bounces.
PL
Paul, how was the throttle response? Jerry
Dave complains it is too fast :). If you don't catch it
quick it can easily exceed 12,000 RPM in a blink.
That is with no load of course.
Actually we don't really know because of the rotational inertia
load of a prop. We will have to wait and find out until
we get a prop on there. And then it will depend on the
prop. Wood and carbon fiber faster metal slower.
Paul Lamar
BTW we are dropping all people on A*O*L in one week. We are still
getting too many bounces. Seems like if I put the name of the bad
ISP in the message they bounce it :)
PL
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.