I added a couple of parts to seal the throttle
push pull control rod with a small Teflon encapsulated
silicon O-ring..

BTW we are dropping all people on AOL in one week. We are still
getting too many bounces.

Paul Lamar

Paul

This looks very good, but I have a question.  I think looking at your
drawings and the pictures you have the unit set up to open when you PULL
on the clevis, am I right?  Normally on the dash you push to accelerate,
will you have a mechanical reversing unit or bellcrank somewhere in the
cable line, or could you make the main plates a tad longer so the slide
could open when you push?  I am hoping this is helpful.

Tony2

It just depends on where you place the 1 and 7/8 holes on the Teflon
slide it self. Push or pull you option.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.