> These are the last pictures I will be able to take
> as the engine is going back to Marc for further
> tuning with a prop load and in the air.
>
> Marc I will update the slide throttle to a sealed version
> and send you the parts.
>
> Jerry, we tried the muffler and it was rather loud at 123 db but
> I was standing right next to the engine in a steel building.
> Half a dozen rotary experienced people were standing around and
> they all said it definitely mellowed the sound of a typical rotary with
> an open exhaust. We did not make any power runs so I cannot say
> if it increased the HP or decreased it.
>
> Paul Lamar
OK, Loud but mellow. What was the rpm and load for the 123 db
measurement? If that was idle, I may have a problem. :-)
Bob W.
About 6000 RPM and 100 HP my guess. I was watching the db meter :)
Similar measurements on similar mufflers have been 104 db at 30 feet
away with prop noise. Tracy and Dave Atkins ran similar mufflers for quite
a few years. Perhaps with a slightly smaller down pipe.
I have the impression the rectangular down pipe is mostly
responsible for the mellow sound as it sounds different than
Tracy's or Dave's. Just a subjective impression.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.
Thanks Paul,
I may try adding some baffels to the down pipe just to see what it
does. 19 db is a considerable difference. Since you weren't 30 feet
away, maybe it won't be quite that bad. I have gotten past the age
where I get a thrill from making more noise.
Bob W.