Mark, or anybody else using Tracy's EFI system.
I had an idea. Since we need more fuel on the top
end for the P-port it occurred
to me we can change Tracy's injector table on the
bench. If you have time to set
it up you will need a scrap crank angle sensor
chucked in a drill press and a
auto parts store vacuum pump. You will also need a
scope.
Just adjust the pulse width's in mode 1 as a
function of the MAP to the
red line and things should be in the ball park for a
first flight.
You can then shift the curve left and right using
mode 3.
I did not do it when I had it on the bench because I
thought the high
buck fuel pressure regulator would be enough. I was
wrong. We then ran
out of dyno time to take the EFI system back to my
hangar and change
it on the bench set up.
BTW the MSD injectors will run up to a 95% duty
cycle.
The 2013 we are using is good for 70 HP each at a
BSFC of .57
at 80% duty cycle or 280 HP at 7500 RPM. It wants to
have
a rich mixture when at full power so .57 BSFC is
about right for a
p-port.
We were running Tracy's default 75% duty cycle at
7500 RPM and as
per Tracy's recommendations only 33 psi fuel
pressure. The MSD
injectors are rated at 43.5 psi. No wonder the
engine is going
lean on the top end. So jack the fuel pressure up
to 43.5 psi and
use an intake manifold referenced fuel pressure
regulator.
Also change the slope of the fuel injector table as
a function
of the MAP of course.
If you want me to do it for you call Dave Lemon
today and have him
not ship the EFI system. I will pick it up and make
the table
changes in the B computer only and then ship it to
you.
No wonder it is going lean on the top end on the
dyno.
I can't imagine a stock Mazda 2nd gen NA injector
would flow
enough for a p-port engine.
It's been a real steep learning curve. Somebody
needs to write
a good book on souping up EFI systems.
Too bad I did not figure all this out ahead of time.
Paul Lamar
Paul,
I'll give Dave a call this morning...and ask him to
hold onto the EFI and harness. If you are able to do
this on the B that would be really helpful.
I'll let you know what he says.
thanks
Mark
BTW is Dave getting ready to ship everything out
today?
Yes I think so but I think he is waiting for a check.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.