>>> We ran the p-port engine again today on the EFI system
>>> and slide throttle. Runs great. Will idle below 1000 RPM.
>>> Starts easily. Idles smoothly more or less under 1500 RPM.
>>> The mixture through out the RPM range is better with
>>> the $200 manifold referenced fuel pressure regulator
>>> but still a bit rich on the low end and a lean on the
>>> high end. We are running out of dyno time to do further
>>> mixture and ignition timing tuning. Max HP was 222. I used
>>> Tracy's Mode three to set the mixture richer by eight clicks
>>> over the entire MAP and RPM range. We did no Mode 1 tuning.
>>> From here on out final tuning will be done with a prop
>>> load in the air at altitude. The EGT's track together within about
>>> 40 F which Dave says is not that bad. Could be a
>>> difference in fuel injectors. Perhaps one runner at
>>> the slide throttle is leaking more air than the other.
>>> No time to build a new sealed slide throttle before Dave must
>>> dyno another engine. We will do one more run tomorrow or the
>>> next day with Jerry's muffler.
>>> Next project is to bench test some fuel injectors.
>>> Paul Lamar
>>
>> Paul,
>> I think the results will only get better with some minor tweaking.
>> George (down under)
>>
>> I hope so. I just revised the design yet again to eliminate
>> all possibilities of air leaks affecting the tuning.
>> More about that later.
>>
>> Paul Lamar
>
> Paul, these are excellent results. Congratulations!! You have now
> proved that the remote injectors work. That is a big deal. As far as
> I am concerned cool side fuel (at least for p ports) just went from a
> dream to a reality. Sooner or later cool side fuel will save someone's
> life.
>
> I am glad to hear you are going to test the muffler while on the dyno.
> I got my fingers crossed. Jerry
>
Paul, how was the throttle response? Jerry
Dave complains it is too fast :). If you don't catch it
quick it can easily exceed 12,000 RPM in a blink.
That is with no load of course.
Actually we don't really know because of the rotational inertia
load of a prop. We will have to wait and find out until
we get a prop on there. And then it will depend on the
prop. Wood and carbon fiber faster... metal slower.
--------------------------------------
Further simplification and better sealing.
Dimensions on request.
Paul Lamar
---------------------------------------------------
Something is missing on the Rev 7 drawing, the clevis and rod have no way
of joining???
Tony2
-----------------------------------------------------
Yep. You need to drill a 3/16th diameter hole after it is assembled
for the clevis rod or push pull throttle cable end. The clevis is drilled
and tapped to fit the push pull throttle cable end.
This revision is the best sealed of the bunch.
Thin gasket material is used between the sections.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.