Dear PAMA,
I am building a homebuilt aircraft and the kit manufacture is not
involved much anymore. I want to replace the existing retract gear with
fixed gear. The design work on the main gear is almost complete. I am
now looking for a nose strut.
Below are some specs on the gear I am looking for. The length is still
an approximation and will likely be shorter by one to three inches.
*Desired specs:*
1. 7" stroke
2. Carry 500 lbs static
3. Need 3/4" of spare oleo, minimum when static loaded.
4. Capable of taking a 5x5 tire (preferred); 4x5 acceptable.
Min fork width: 6.0"
Min fork height, axel to inside top: 7.5"
5. Length: mounting point to axel 22.5 (for 4x5 tire), 21.0 (5x5 tire)
for static condition, loaded.
6. Length: mounting point to axel fully compress: 21.5" (4x5 tire),
20.0" (5x5 tire)
7. Length: mounting point to axel fully extended: 28.5" (4x5 tire);
27.0" (5x5 tire)
*8. Want about 1" of trail. More then 3/8" but not more then 2"
9. Oleo will be mounted between 1-5 degrees forward.
*Estimated.
If you have anything like this, or know where I can get one please let
me know. Thanks much.
Sincerely,
Jim Griffin
760-430-4701, ext 13306
[
mailto:jhg_53@yahoo.com]
------------------------------------------------------------------------
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.