Subject: P-port slide throttle.n Revision 7
From: Rotary Engine
Date: 7/6/2005, 1:14 AM
To: AA-me



This revision is the best sealed of the bunch.
Thin gasket material is used between the sections.

Paul Lamar

Paul,
Good idea! as it will stop ( the possibility) of one inlet scavenging from
the other.
George ( down under)

That should have been between the "plates" and not the "sections".
No gasket material between the sections. There is only a few thousands
of an inch clearance between the plates and Teflon so I don't think there
is a significant air flow between them since they are a good 2 1/4
inches apart with solid Teflon between the holes.

Think of it as a small hole with an area of about .007 square inches.
A = pi X r^2     A/pi = r^2 = .002228"  r = .047"
Its a hole with a diameter of .094" at best.

The ratio of the area's is 2.76 square inches (pipe) over
.007 square inches (leak) or about 400 to one.

BTW The two vacuum sensor holes, one in each runner, are T'ed
together anyway and they are larger than
.094" inside diameter. Perhaps a thing to try is taping off just one
runner and see if it makes a difference in EGT's, MAP or HP.

There is roughly 400 cubic feet of air per minute going in the
engine at 7500 RPM. Since the inside area of one pipe is .0192 square
foot that is a air velocity in the pipe of 10,416 feet per minute
or 173 feet per second or 118 MPH.

Paul Lamar

-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.