Paul, What should be the length, diameter, thickness, material type, and
bend radius for the intake tubes for the normally aspirated Renesis?

Do you have any drawings of a completed intake setup?  Throttle body to
engine, injector ports, fuel rail, etc?

In other words, have you already, or can you engineer the damn thing for me?

While you are at it, don't forget the exhaust!!! :>)

Thanks,
Bill Bradburry


I have no idea :) Too new. Nobody has flown a high power version yet
to my knowledge. I'd be guessing. You would be on the cutting edge.

Tracy is flying a low power RX8 engine and getting about 200 HP
with this set up at 7500 RPM. As I recalled he lengthened the pipes a
bit since these picture were taken. His ports have probably been street
ported by Bruce Turrentine.

Paul Lamar