Subject: P-port slide throttle.n Revision 7
From: Rotary Engine
Date: 7/10/2005, 7:51 PM
To: AA-me


The Teflon holes are easily cut with a hole saw. I am not sure you can find
a 1 7/8th inch hole saw however. You might need to get close and trim the hole
with an exacto knife. I stuck mine in the mill and used a boring head.
A very quick job as Teflon is soft and easy to cut.

Paul Lamar


I have very good results cutting holes in plastic with wood cutting paddle bits. They make a very clean hole and you get a nice washer as a bonus.
Bulent



-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.