Subject: P-port slide throttle.n Revision 7
From: Rotary Engine
Date: 7/10/2005, 7:53 PM
To: AA-me



>> You can put me down for a set of p-port intakes.
>> Blake
>> >> That is at least 4 sets so far. Do I hear five?
>> >> Paul Lamar
> > > Paul,
> At a price point near $50, that's a deal I can't refuse.  Put me on
the
> list for one.
> Aubrey
> > > What are we talking about for $50?  Is this a slide throttle, or a
complete
> intake?
> > Bill Bradburry
> > Just the flat parts. You need tubing, trumpets, fuel rail and a plenum
with
> injector holders. I have some trumpets if anybody is interested.
> $20 bucks cash for two ($10 each) with a stamped self addressed
envelope. Let
> me know.
> > 3 attachments for the A O L challanged.
> > Paul Lamar

Paul

Sorry,  I was confused.  I thought you were selling the P-ports.  As for
the
throttle I can get it punched out next door.  Let me know if you if need
a
quote.  Shipping might kill you though.  How do you fabricate the Teflon
holes?  Water jet?

Doug in Japan

I would be interested in that quote.

The Teflon holes are easily cut with a hole saw. I am not sure you can
find
a 1 7/8th inch hole saw however. You might need to get close and trim
the hole
with an exacto knife. I stuck mine in the mill and used a boring head.
A very quick job as Teflon is soft and easy to cut.

Paul Lamar


Paul,

  A 1 7/8 hole saw should be pretty common. I have one that is a Lennox,
and I would think they still make them that size. Mine is only a few years
old. Should run about $25 - $30 with an arbor.

  Ben Schneider

-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.