Subject: P-port slide throttle.n Revision 7
From: Rotary Engine
Date: 7/10/2005, 8:00 PM
To: AA-me



>> >>> OK I guess I will have to do it. How many people want a set?
>> >>> Speak up. My guess is the whole set will be less than $50.
>> >>>
>> >>> Paul Lamar
>> >>
>> >>
>> >> Paul,
>> >>
>> >> I'm interested in a set.
>> >>
>> >> Regards,
>> >> Bill Siegel
>> >>
>> >>
>> >> I'll take one for the 13Brew tt.
>> >> Marc Wiese
>> >
>> >
>> > Will they fit a 6-port Renesis?
>> >     Mal Booth (downunder)
>> >
>> > No. P-port only.
>> >
>> > Paul Lamar
>>
>>
>> Sorry, I meant a P-Port modification to a Renesis which I presume is no
>> different to a P-Port 13b?. By the way We ordered two Renesis donks
from
>> Rupert in Brisbane today,- great to deal with.
>>                   Mal Booth
>>
>> ---------------------------------------
>> There is a clearance issue with the water in port (lower) on the RX8
> engine
>> front cover. I have not tried it with a RX8 engine yet. Perhaps you
>> will need a right angle water in port adapter. Here is a pic from Don
> Dunbar.
>> Also you will probably not be able to run the apex seal oil pump.
>> No real loss as most people mix apex seal oil with the fuel.
>>
>> I would move the slide throttle out away from the block another
>> inch or two to clear the water in port right angle adaptor.
>>
>> 2 pics for aolchallenged. 3 days to aoldoomsday.
>>
>> Paul Lamar
>
>
> Mal,
> Which ones did you order the 4 or 6 port - I would have pick-them out
for
> you had you asked.
> There are some that are better than others. I went over and Picked-out
the
> 6
> for Don Dunbar.
> George ( down under)


G'day George,
   Many thanks for your very kind offer, we didn't like to trouble you. We
ordered 2 six-ports, one without inlet manifold, (I want to go
peripheral).
Rupert is to arrange transport on Monday arvo, I don't know how soon he
will
ship 'em. If it is not too much trouble/too far to go, perhaps you could
ring him & delay shipment until you can have a look for us? Unfortunately
we
are in absolutely NO hurry! Hope to see you re your gearbox EVENTUALLY!
              Thanks again,
                      Mal Booth.


Mal,
I rang Rupert and he is happy for me to select two for you.
Where are they to be sent ?
I will be happy to see my gearbox, eventually as well!!
I was called away on my last reply to you and was saying I personally
believe a RX8 PP would be very good!
George


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.