Subject: P-port maifold pressure tap
From: Rotary Engine
Date: 7/11/2005, 5:28 PM
To: AA-me

I had a long talk with Tracy on this subject.
The question is what is the true manifold pressure. We need to know
that number to set the pulse width of the fuel injectors. Since
Tracy samples it for only a millisecond or so it could be affected by
a lot of factors. We know there are pressure pulses in intake
and exhaust systems. The question is; what part of the pressure
curve is occurring when Tracy samples the pressure?

Tracy samples the pressure for firing the injectors on rotor two
right after (within a few microseconds) he fires rotor
one's ignition plugs (about 20 degrees BTDC). So far I have not been
able to talk him into taking many samples and averaging the data.

We discussed how to measure the pressure wave in the p-port intake manifold
as a function of e-shaft angle during one cycle per revolution of the
e-shaft. The max pressure will occur at different times depending
on the RPM and the length and diameter of the runners. So far suggestions
have been; feeding the output of the high speed pressure sensor into a PC
audio input card or the microphone jack of a note book computer. Tracy
pointed out the problem with that are those are AC inputs and we need
absolute numbers from  the pressure sensors. We also need to relate
them to the ignition pulse. That led to  using a storage oscilloscope
instead.

The price of battery powered hand held storage oscilloscope have dropped
recently and they are fast enough to do this job. At 7500 RPM it takes
the e-shaft 8 milliseconds to make one revolution. In other words
that is only 125 revolutions per second. Since the response times
of the pressure sensors is only 1 Kilohertz most hand low cost held
oscilloscopes are fast enough to do this. They are also fast enough
to measure the pulse width of a fuel injector if you want to
use them for that. This device will help greatly when designing and
developing intake manifolds.

Here is a intake manifold pressure pulse from a Mazda tech paper
SAE 841017 on P-port intake manifolds.

Here also is a pdf file for some hand held storage oscilloscopes.

When Mark gets his p-port engine in his Mustang II airplane I will pop
over to Denver and help tune it with what ever test equipment
I can beg, borrow, bring, or steal :)

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.