Paul, can you read this attachment.  Its an IGS out put from solid works.

I modified

the slide throttle a little and would like your comments.  We can cut

radius's really

easily.  And I was wondering if we could use a Rod threaded perpendicular

to the

slide with a 3/32 SS rod to push and pull the slide. This would eliminate

the slot

and subsequently the minor leaking at the slot point.  If I'm off base

here please

let me know.  T.W.


Really really great idea Tom. Why did I not think of that? :) Simplifies

things

greatly with no slots in the covers required. You will have to go up to

1/4 inch

thick Teflon and spacer as the throttle control rods are usually 3/16 inch
in diameter (10-32 threaded). Up til now I have been using 1/8th inch

thick

Teflon and spacers. A 3/32" control rod is a bit wimpy :)

Make the steel (green) button a little larger
to be sure it does not roll over.


Paul lamar

Paul
I'm in for one revision 8 material cut @ ~ $50.

Thank you
Terry Adams

Tom Weber will probably be making these. Tom, are you saving all these
request.

Paul Lamar