Subject: P-port maifold pressure tap
From: Rotary Engine
Date: 7/12/2005, 11:57 AM
To: AA-me



It seems the best solution discussed is to put a restrictor in the
vacuum line to the MAP sensor.  A metal vacuum hose coupler drilled to a
specific size seems to be popular.  The only "surge tank" left is the
unavoidable minimal volume of the MAP vacuum line.  (The restrictor can
be at the manifold, the MAP sensor, or anywhere in between.)  The
restrictor effectively controls maximum rates of pressure change in the
MAP sensor side of the vacuum tube.  Drill to size to get your desired
response rate.

       The high-end laboratory pressure gauges use a more clever orifice
to damp pulsations. They drill a hole and put a wire through it. They then
put a 90+ degree bend on both ends of the wire. This makes a restriction
like a tiny hole, but is very resistant to plugging up. Much more reliable
than a tiny hole.

       Bill Dube'

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.