Paul and interested Renesis want-a-bees
These two pages of discussion answered many of the questions I have been
bugging Paul about for 6 months now:) The talking points were thrown around
before the Renesis engine was introduced but the train of thought is still
valid.
Go here:
http://www.rx7club.com/printthread.php?t=80067&page=1&pp=40
I gathered the following;
In essence the Renesis engine increases efficiency mainly at the LOW rpm
end, which Paul has shown by driving down the highway (in his car) at very
low hp settings. Mazda ex engineers told me the same thing months ago.
Certainly Paul's 20% power settings are to low to use in our airplane
applications.
The Renesis does have lower emissions through out its power range because
it recycles only a tiny percent of exhaust gases but can only make its'
claimed 230+ Hp only at the high end of the power curve with high
compression rotors. It does have other improvements such as housing design,
water pump, lighter weight, nice idle, etc. but lets put those advantages
aside for now.
So if you can take advantage of these high rpms then the Renesis might be
the way to go. For instance.
I will be using a 76" dia. AeroComposites C/S three prop so the engine rpm
could be as high 7980 on climb out. Using a 2.85:1 gearbox and prop rpm of
2800 (max. for this 76" prop.) results in 7980 engine rpms. Assuming the
gear box is 95% efficient then at about 8,000 rpm (or 234Hp according to my
Japanese version data) the HP the prop sees will be about 222Hp. Other
accessories on the engine are absorbing power as well but at this point I
don't know how engines are rated. Gross power or net. [With the accessories
or without] I suspect the net power may be closer to 210Hp.
It seems the Renesis multi- length manifold breathes extremely well, and
with the later closing of the exhaust port can obtain a little more push
(read increase in HP) from the expanding exhaust gases.
This translates to a higher efficiency so perhaps better BSFC at some rpms.
Better fuel mileage taxing to the runway?
For auto N/A engines the complex 6 port manifold is fine. For airplanes IMHO
the P port would be the way to go. I agree with Paul, perhaps Tracy made the
right choice. Two less ports to epoxy fill. Now if we could only get him
to P-port that engine. With the development of the slide throttle the P-port
makes everything including adjustable length manifolds much easier to make.
If you want a turbo, consider it for a small amount of boost only since the
light weight rotors already provide a high 9.7:1 C/R. Turbos applications
will shine on 'normalizing' the engine RENESIS for flights to higher
altitudes. The exhaust will probably have less of the 'ump' compared to the
P port exhaust but still plenty to drive a turbine. Different
characteristics only. You will need a custom turbo in any case to fly safe
in an airplane.
If you can't use the RENESIS high rpms because of prop speed limitations, go
with a P ported 13B or turbo side port 13B and live with the higher
emissions. With a smooth exhaust system both can be configured to get you
over 300 HP.
Add another (intake) P port convert to the list:)
Doug in Japan
Doug if you go here you can download the SAE paper in question
along with a bunch of other good ones. renesis_paper.pdf
Espeically the Lemans p-port engine paper.
4-rotor-1-5.pdf
4-rotor-6-11.pdf
http://www.thecarricos.com/ACRE/
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.