Subject: [Fwd: Re: P-port maifold pressure tap]
From: Rotary Engine
Date: 7/13/2005, 10:42 AM
To: AA-me


>It seems the best solution discussed is to put a restrictor in the
>vacuum line to the MAP sensor.  A metal vacuum hose coupler drilled to a
>specific size seems to be popular.  The only "surge tank" left is the
>unavoidable minimal volume of the MAP vacuum line.  (The restrictor can
>be at the manifold, the MAP sensor, or anywhere in between.)  The
>restrictor effectively controls maximum rates of pressure change in the
>MAP sensor side of the vacuum tube.  Drill to size to get your desired
>response rate.

         The high-end laboratory pressure gauges use a more clever orifice
to damp pulsations. They drill a hole and put a wire through it. They then
put a 90+ degree bend on both ends of the wire. This makes a restriction
like a tiny hole, but is very resistant to plugging up. Much more reliable
than a tiny hole.

         Bill Dube'



That's not the only place that works. Try the shimmy dampeners on Cessna's-I did exactly the same thing on a hydraulic shimmy dampner that shuttles fluid back and forth to dampen the nosewheel oscillations. The orfice valve between the front and back of the dampner has a small hole, that is where the wire goes.
Marc W.


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.