Subject: Why the P-port throttle? (was: P-port maifold pressure tap.)]
From: Rotary Engine
Date: 7/13/2005, 9:42 AM
To: AA-me



        I've only been following this thread for a short while, but I
can't understand what advantages there might be to locating the throttle
plate at the port opening. It seems like there are several serious
disadvantages.

1) Manifold pressure is difficult to read.
2) Flow disturbance right at the port.
3) You have to build the throttle yourself.

        Is there some major advantage of locating the throttle next to the
port that I am missing?

        Bill Dube'

It was discovered by NSU 45 years ago that the p-port engine idled
better if the throttle plate was right next to the rotor housing.
Power Sport verified this about ten years ago. We just verified it
again. The reason this happens
is the tuned intake port runner pressure  goes negative while the intake
is open sucking exhaust gases from the exhaust port through
the depression in the face of the rotor into the intake runner.
These exhaust gases cause the engine to misfire at idle.
At high power and high RPM this effect is minimal.

Placing the throttle plate next
to the rotor housing minimizes the volume of exhaust gases
in the intake runner during idle. The idle is not as good as an all side
port engine but acceptable for an aircraft and racing engine.


The same thing happens
to a much lessor extent with a side intake and peripheral
exhaust port engine. This misfire causes serious problems
with idle fuel consumption and emissions. That is the real
rational for the side exhaust port RX8 engine that completely
eliminates all valve over lap.


Everybody knows a p-port will generate more power at any RPM
from 2000 RPM up and that includes a side port RX8 high power
engine. The Lemans engine was 120 HP per rotor at 6000 RPM
or 240 HP. We are close to the Lemans engine with our P-port
engine on carbs no less. We are not quite there with the
EFI version as we are still trying to get enough fuel
on the top end. We will solve that problem soon.

The reason for the slide throttle is the throttle plate is
completely out of the runner when the throttle is wide
open stream lining the inside of the runner perfectly.
That results in more power. At anything over 8000 feet
the throttle is always wide open in an aircraft engine.
Same goes for a road racing engine.

You don't have to build the throttle plate yourself.
Tom Weber is cutting out low cost parts on an NC plasma
cutter and Ed Kelpies will weld it up for you for
way way less than $900 :)

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.