Determining the shape of the intake pulse.
This is from Motorola AN318.rev2.pdf
http://www2.hibbertgroup.com/freescale/main
Should be real easy to hook this up to your intake manifold
and a hand held scope (rather than the microcomputer shown)
and monitor what is going on in your intake manifold at any RPM.
I am not sure what part numbers for pressure sensors
that will work here but the MPX5xxxx sensors should work for sure.
All you need is a cheap one chip 5 Volt voltage regulator from Radio
Shack. It should then work off the 12 volts in your car or
airplane.
BTW This is for all you assemble language programmers out there
doing your own EFI system design.
If memory serves me correctly... if you take eight 10 bit (1024 decimal)
equally spaced samples during the time the intake port is open
and add them up that is 8,192 or a 13 bit number. No problem as most
microcomputers deal in 16 bits these days. If you then shift
one bit right four times (same as dividing by four) you will
then be back to a 10 bit number which should be roughly proportional to the
total amount of air in the intake port. No need for any floating point
math.
10 bits 1024
11 bits 2048
12 bits 4096
13 bits 8192
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.