Subject: Ultimate pressure tap location.
From: Rotary Engine
Date: 7/16/2005, 9:11 AM
To: AA-me

Here is another much simpler and much more accurate method of determining
how much fuel should be injected. Sample the pressure in the intake
chamber directly, right after the intake port closes using the currently
unused  apex seal oil injector hole. No software or hardware changes
required other than moving the time the pressure sample is taken.
No effect on the current plenum system other than this is a way more
accurate way of doing it. What you are doing here is directly measuring
the total amount of air that actually made it into the engine.
It will probably even work in a piston engine and is far cheaper
than a mass air flow sensor.

Now that is a multi million dollar patentable device if I ever saw
one and if it were not  for the fact you are reading about it at this
very moment :)

next day --------------------------------------------------

Forget everything that went before. This is the final answer.

Mark, I am going to make up a couple of these pressure tap fittings
for you that screw into the oil injector holes. Just so there is no
mistake. This jpg shows where the intake manifold taps go. Total
quantity or mass of air is automatically measured given the air
temperature going in.

If Tracy changes the point where he samples the data to about
a 30 degree e-shaft  window where the intake port is closing and
the apex seal oil hole is still open this will work gangbusters.

Right after the first apex seals passes this oil hole the pressure
will start to drop rapidly and build up again until
the next apex seal closes the intake port again. Should be a
nice pressure spike in this hole.

Anything close to closing and before the oil hole is passed should
work great.

BTW this will work very very well with a rotary but not so hot
with a piston engine. A piston engine, unlike a rotary
uses the exact same chamber for intake, compression,
expansion and exhaust consequently there is a huge pressure spike
when the engine fires. The pressure sensor therefore must
be extra robust.

I am really excited about this. This is a major breakthrough.

Paul Lamar


Paul

Nice idea. Anyway to sample air temp at that location at the the same time
or is that going overboard?

Doug in Japan

No I think sampling the air temp in the runner just shy of the
rotor housing would be sufficient.


Paul Lamar


-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.