> Paul,
>
> Thought you might have interest in our engine program? Contact me
at
> your convienence. WWW.RotaMax.Net
>
> Thank You
> Eric Barger President
> Thermo Fan Inc 419-694-1400
> eric@thermofan.com
> RotaMax Inc 419-694-3000
> eric@rotamax.net
>
>
>
> The price of these engines is $6000. They use intake charge
cooling
> instead
> of oil....?????
>
> Bill Bradburry
>
I was wondering how the charge cooling works myself??
New Renesis EFI ready engines are available for $5700.
Chad Jensen
Is that an apples to apples price? The Rotamax looks like it comes
ready to run - except for radiator and coolant hoses. The write up
says they provide alternator (generator?) & starter, carburetor, etc.
What comes with the Renesys for $5700?
Joe Hull
Bellevue (Seattle), Washington
Cozy MkIV #991 (working on Engine & Electrical & Finishing)
http://www.maddyhome.com/canardpages/pages/JoeHull/index.html
Probably not quite apples to apples, but the Renesis is ready to put out
around 250hp vs. 150 for the RotaMax. Looks like a great setup to me,
but
the horsepower available from the Renesis will be worth a little extra in
price. I'll check with my friend to see what came with his Renesis, but
I
know for sure that it did NOT come with radiator, alternator, or coolant
hoses. He does have his PSRU, and I'll find out if that was part of the
$5700.
Chad Jensen
That the retail price on a short block Chad. No nothing other than
the basic block. Lots of people get them for the dealer price or
$3800. Slightly used are going for less than that with everthing.
Paul Lamar
-
Thanks Paul, I figured you would be a little more clear on this than me.
What is charge cooling?
Chad Jensen
Charge cooling is used in small rotary engines to cool the rotor.
The cool intake fuel air charge first passes through the rotor and back
outside the housing. It is then is fed into the engine through
a side or p-port to be burned. Trouble is, it picks up heat cooling the
rotor reducing the density of the charge and therefore the HP
that can be obtained. Not to mention the lousy volumetric efficiency
one obtains with such a torturous intake manifold path.
Saves the cost of a pressurized oil system and oil cooling the rotor.
Paul Lamar
Thanks for the explaination. Still learning a lot here!
Chad
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.