Subject: 13b from '88 RX-7
From: Rotary Engine
Date: 7/23/2005, 4:07 PM
To: AA-me

I have an opportunity? to buy a 13b out of a wrecked 88 RX7.  What should I
look for to be sure that the engine is rebuildable? (it is still in the car)
also, what out of the engine compartment should I be certain that I get in
the deal?  The oil cooler is already gone.  What should be a reasonable
price?

I hope I get some responses by Monday.  Help!

Bill Bradburry

88 are not ideal. Some major changes were made in 89.

You should do a compression check at minimum. If it fails
a compression test it is of core value only. Perhaps
$300 at the most but try $100 first. Could be rusty inside if it sat
around for years.

Get everything you can get as parts are saleable.
Fuel pump is important. Starter, flywheel (if automatic), alternator, etc.
Too bad about the oil cooler. Valuable part.

Paul Lamar

Thanks, Paul..

Without getting too involved, what kind of changes were made in 89?

I don't have any way to do a compression check.  The car is in the middle of
a pasture with other junk cars around.   I have been trying to figure out
how to even see if it will rotate or if it is "frozen".  Will it probably be
rebuild able no matter what if the block is not busted? (not likely from cold
weather in Florida)  Where will the ECU be located?  Under the hood or under
the dash?  Should I try and get that as well?  Are these 4 port or 6 port?
I noticed that Tracy had an early 6 port which he swapped for a 4 port.  How
early was the 6 port?  How different was it from the 6 port Renesis?

Bill Bradburry


As I recall it had something to do with the phasing gears.
12 pins rather than 9 but I am not sure.
Also as I recall the side housings and phasing gears were
ion nitrided. Machined combustion chambers for uniform and higher
compression ratio. New tuned intake system with 160 HP NA. 200 HP turbo.
Don't quote me on this as we talked about this five years
ago or so. I also think Tracy mentioned something in his book.
There could be some other changes as well.

Paul Lamar


Any chance this is a convertible?

Tony Snow

Yes on the ECU. It is under the passenger side kick panel
as I recall. Unplug it and feed the connector through the
large grommet in the firewall.  Everything is rebuild able. It all
depends on how many parts need replacing. The big problem is the
side housings will wear faster than the hardened 89 versions.
If the intake manifold is off or in any way disassembled
water made its way into the engine so it WILL be rusted internaly.

My guess it is a $100 engine.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.