Now if I could just find out how to control the stepper motor on the oil
injector pump, and what is the purpose of the vacuum feed to the
injectors?
Ian Beadle
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
C & D pins are 12 Volt supply. E,F,A & B pins are stepper coils 1,2,3,&4
respectively. Ground side is switched. There is also a position switch
which is monitored by the PCM to keep track of the amount of oil
being metered. Step up and step down.
Oil metered is a function of RPM, coolant temp and amount of intake air.
The oil nozzle receives barometric pressure to prevent the
negative pressure in the intake chamber from being applied to the oil
inlet.
There is also a one way valve to prevent oil from flowing out of the
air hose side when positive pressure is in the intake chamber.
BTW As I was saying this is a good place to monitor the vacuum or MAP for
fuel injection purposes.
There is a fail safe mode when the PCM detects a insufficient amount
of oil it then limits the engine RPM. Limp home mode. This prevents
seizure of the apex seal. As I said many times before one of
the functions of the apex seal oil is to cool the seals.
One of the advantages of the RX8 engine side exhaust is the apex seals
run cooler.
Good luck on controlling the stepper motor. BTW that is an
extremely expensive part at around $1500 US.
If it were me I would forget it and mix 2 cycle oil with the fuel.
Paul Lamar
That is not like you Paul (Thanks for the info). Controlling a stepper
motor should be a good challenge. Right up your street. Actually running the
motor at the full speed setting and feeding it two stroke oil with the $90
Richard Sohn adapter would probably be OK as we run our motors at high speed
most of the time.
The control could be 4 micro switches and a cam on the throttle. I will have
a play.
By the way IMHO premixing the oil at an away airfield in 100 degrees and
half a gale is a pain in the proverbial.
Ian Beadle
You should know being the outback rotary engine pilot meister :)
The main reason Mazda goes to all that trouble with the stepper
motor is the draconian emissions rules in the US and Japan.
I kind of like Mazda using the PCM to monotor the oil feed to the
apex seal oil injectors and shutting down the engine if the oil injection fails.
There are a lot of rotary engines in junkyards around the world
where the cheap 10 cent nylon lines feeding the apex seal oil hardened and cracked
without the owner being aware of what was going on. Those lines need to
be changed every eight to ten years no matter what. It blew me way to discover
the RX8 engine still had cheap nylon lines. If it were me I would design those
critcal oil feed lines in steel. Never the less the PCM apex seal oil monitoring
feature on the RX8 engine should extend the life of the rotary in automotive
service to well over 500,000 miles. It will take another 20 or 30 years to
find out:)
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.