Here is a picture Ian's RX8 high power manifold sent showing
the two tubes protruding from the intake manifold into the
primary ports.

BTW this jpg also shows Ian's RX8 manifold cut down. Ideal
for welding  on pipe or tubing bends to gain a low profile
aircraft intake manifold.


Paul Lamar

G,day Guys

Sure gets complex. I have cut the six port manifold down a bit more to get
the air box under the James cowl. See pix. The thick black pipe is the air
feed to the injectors. I have put it on to the fitting under the oil filler
cap because I think that is where it came from. Yes/no?
I am hoping to use a single pole,  make before break, rotary switch on the
other end of the throttle body shaft to control the stepper motor.
(Going flying with Don Dunbar in the Jabaru tomorrow)

Happy flying Ian Beadle

I only got one picture.

Looks good. Ian ought to work fine.
Hey take some pictures :)

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.