Subject: M2 S-Beam Engine mount at an angle
From: Rotary Engine
Date: 7/25/2005, 5:55 PM
To: AA-me



Hi Jerry-
I installed the engine mount on the M2 over the weekend - mount  points
lined up very well & only needed a wee bit of convincing to get the
bolts through.  One thing I immediately noticed was that the S- beam is
at an angle.  I measured the airframe at the main spar and it claimed
to be level.  The
SBeam was measured at exactly 1 degree off horizontal.   I don't have
the best angular measure in the world, so take this with a little
grain of
salt.
Anyway -- I can't for the life of me remember whether the angle was
something planned for (i.e., thrust angle or something like that) or
whether it was expected to be level.
Thoughts?
Mark
I don't know what Jerry did for a rear mount but it should
be adjustable. Here are a few ideas.


Interesting that you bring up that question, Paul.  There is no rear
mount.  I was wondering whether the entire thing truly cantilevered
off the SBeam.  We do have a firewall hard-point top dead-center not
being used by the rest of the mount.  So something like in the KIS
picture ought to be trivially simple.

Sounds like another point to get clarification on.

Mark


Yet another idea is how Don Donbar did his. It might interfere
with the intake plenum however.

Paul Lamar

I find the statement about me not supplying a rear motor mount  very
strange as I repeatedly brought this up as something they would have
to provide for themselves.  For the record I have not supplied the
rear motor mount for anyone and have no intention of doing so unless
it would be for a Tailwind or the RV-4 or 6 taildraggers.      Jerry

You would weld something if somebody gave you a drawing
of what they wanted ... right Jerry?

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.