How does one tell a flywheel from an automatic 13b vs. a flywheel from
a manual 13b?
I began adding Tracy's RD-1C & Jerry's Shertz Beam to the engine
today, only to be stopped on the 2nd step. Tracy makes clear that an
automatic flywheel is necessary. On step 2 I was unable to get the
dampener plate to sit flush on the flywheel I have -- so I am
suspicios that it is the "wrong" flywheel.
Besides now having to probably find a new flywheel, am I at risk of
also having to change anything else? i.e., the counterweight?
Mark & Mark
Real easy. One you can pick (the auto TX flywheel (flex plate)) and
the other one is glued to the ground :)
The automatic has a bunch of small holes in it and is made from
sheet metal.
Definitely on the counter weight. Send email to Dave Lemon
at Mazdatrix on which counter weight to use as he built the engine. He might have
one in stock.
Another problem: the end of the e-shaft (where the nut is) has some
sort of residue inside of it. In order to mount the redrive, the
pilot has to be able to fit into the e-shaft & it is currently binding
on this residue. I have tried zapping it with solvents, but no dice.
Any hints on what this stuff is & how to get rid of it? I am not
excited about sticking a grinder in there, since I would no doubt
screw up the interior finish. Maybe a heat gun?
Mark
Also ask this question of Dave. I think it might be some sort
of Loctite product.
A heat gun might help.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.