>
>> I have an opportunity? to buy a 13b out of a wrecked 88 RX7. What
should
> I
>> look for to be sure that the engine is rebuildable? (it is still in the
> car)
>> also, what out of the engine compartment should I be certain that I get
>> in
>> the deal? The oil cooler is already gone. What should be a reasonable
>> price?
>>
>> I hope I get some responses by Monday. Help!
>>
>> Bill Bradburry
>>
>> 88 are not ideal. Some major changes were made in 89.
>>
>> You should do a compression check at minimum. If it fails
>> a compression test it is of core value only. Perhaps
>> $300 at the most but try $100 first. Could be rusty inside if it sat
>> around for years.
>>
>> Get everything you can get as parts are saleable.
>> Fuel pump is important. Starter, flywheel (if autoamtic), alternator,
>> etc.
>> Too bad about the oil cooler. Valuable part.
>>
>> Paul Lamar
>>
>> Thanks, Paul..
>>
>> Without getting too involved, what kind of changes were made in 89?
>>
>> I don't have any way to do a compression check. The car is in the
middle
> of
>> a pasture with other junk cars around. I have been trying to figure
out
>> how to even see if it will rotate or if it is "frozen". Will it
probably
> be
>> rebuildable no matter what if the block is not busted? (not likely from
> cold
>> weather in Florida) Where will the ECU be located? Under the hood or
> under
>> the dash? Should I try and get that as well? Are these 4 port or 6
>> port?
>> I noticed that Tracy had an early 6 port which he swapped for a 4 port.
> How
>> early was the 6 port? How different was it from the 6 port Renesis?
>>
>> Bill Bradburry
>>
>>
>> As I recall it had something to do with the phasing gears.
>> 12 pins rather than 9 but I am not sure.
>> Also as I recall the side housings and phasing gears were
>> ion nitrided. Machined combustion chambers for uniform and higher
>> compression ratio. New tuned intake system with 160 HP NA. 200 HP
turbo.
>> Don't quote me on this as we talked about this five years
>> ago or so. I also think Tracy mentioned something in his book.
>> There could be some other changes as well.
>>
>> Paul Lamar
>> hi Bill, i have bought a half dozen or so for $200 or less., imho
you
> are wize to use only 89 and newer because of the improvments mazda made.
> brew 93-99 are best at slightly more money. wyo. walt.
Walt,
Could you make a list of the items / improvements.
Bob Boberrorusa Wichita Ks.?
-hi Bob, i decided several years ago after studying the changes that i
would only use 89 and newer engs. i cant remember all the changes, the
rotors were lighter and machined for greater accuracy, the side housings
were strengthened, the through bolts were changed, the gears were heat
treated and pinned better, in 93 they machined the water jackets for better
cooling, racing probably was responsible for most mods. walt.
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.