>>>>>
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll
<http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll>?
>>>>> ViewItem&item=4564632860
>>>>> This prop belongs to a friend of mine and would be good for
>>>>> people with
>>>>> 2.8
>>>>> PSRU and 20B engine.
>>>>> Bulent
>>>>> Paul or Vance, would this prop work on the PPort 13B? T.W.
>>>>> I suspect it would.
>>>>> Vance? 275 HP at 7500 eng RPM
>>>>> 2600 prop RPM. Come to thing of it Tom vance is at OSH.
>>>>> Paul Lamar
>>>>>
>>>> This sounds like a candidate for my p-ported 13b. I'll take a
>>>> look at
>>>> at the listing when I get home tonight -- ebay is blocked here
>>>> at the
>>>> office.
>>>> Mark
>>>>
>>> Bulent-
>>> Can you get the details on this prop? Someone was kind enough to
>>> email me a jpeg of the ebay listing & the prop is definately a
>>> contender for what I need. Now I need to nitty-gritty like
>>> diameter,
>>> pitch. hub hole spacing, etc.
>>> Mark
>>> Is'nt this prop set for reverse rotation, the 2.85:1 is normal
>>> rotation I
>>> think.
>>>
>> John
>>
> You think right. The prop is set for normal(Lycoming) rotation
Craig Catto can plug the bolt holes and drill new ones from the
opposite side to reverse rotation, which will work if you are also
going from pusher to tractor. I have a Catto 3 blade also intended
for a Velocity that the 1O 360 200 hp engine could not turn. Strange
this would come up twice. Jerry
Oh, I didn't think about re-drilling the holes... I did't consider this
prop because the bolt holes were too big, but I could probably have this
fixed by Craig... Will give him a call.