If your hose connections look like this you need to change
them to silicone rubber hose and constant torque
hose clamps. You know who you are.
We have had two crashes so far when cheap automotive
black hose and cheap worm drive hose clamps like this blew off.
Here is what I have to say about it in my article "How to Cool
Your Wankel".
http://www.rotaryeng.net/cooling.html
"If AN hose and fittings are not used dollar-an-inch
high quality blue silicone rubber hose must be used with constant torque
hose clamps made by the Breeze Co. Constant torque hose clamps keep a
constant pressure on the hose as the aluminum hose barb expand and contract
underneath it. Automotive black hose and 50 cent hose clamps are not going
to cut it. Several rotary powered airplanes have crashed destroying years
of work and untold amounts of money because the builders ignored this very
very important detail."
I'll upload three pictures of bad examples I saw this year at OSH
in this message and three pictures of the right way
to do it in the next message. The last picture in this
group of three shows two clamps being used on what
appears to be an ordinary pipe with no hose barbs. Not a good idea.
With no hose barbs I don't think that is going to save you.
next message ---------------------------------
OK this is the right way to do it.
The last picture was taken at OSH of Chuck Dunlap's
cooling system connections.
BTW this can happen without warning at anytime.
Usually it happens on take off when the barb is still
cool but the coolant pressure is building up.
On an 1.4 inch ID hose barb the force tending to seperate
the hose from the barb at 30 psi is 46 pounds.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.