Subject: M2 S-Beam Engine mount at an angle
From: Rotary Engine
Date: 7/31/2005, 6:09 AM
To: AA-me


>> Hi Jerry-
>> I installed the engine mount on the M2 over the weekend - mount
>> points
>> lined up very well & only needed a wee bit of convincing to get  the
>> bolts through.  One thing I immediately noticed was that the S-
>> beam is
>> at an angle.  I measured the airframe at the main spar and it  claimed
>> to be level.  The
>> SBeam was measured at exactly 1 degree off horizontal.   I  don't have
>> the best angular measure in the world, so take this with a little
>> grain of
>> salt.
>> Anyway -- I can't for the life of me remember whether the angle  was
>> something planned for (i.e., thrust angle or something like  that) or
>> whether it was expected to be level.
>> Thoughts?
>> Mark
>> I don't know what Jerry did for a rear mount but it should
>> be adjustable. Here are a few ideas.
>>
>
> Interesting that you bring up that question, Paul.  There is no  rear
> mount.  I was wondering whether the entire thing truly cantilevered
> off the SBeam.  We do have a firewall hard-point top dead-center  not
> being used by the rest of the mount.  So something like in the KIS
> picture ought to be trivially simple.
>
> Sounds like another point to get clarification on.
>
> Mark
>
>
> Yet another idea is how Don Donbar did his. It might interfere
> with the intake plenum however.
>
> Paul Lamar
I find the statement about me not supplying a rear motor mount  very
strange as I repeatedly brought this up as something they would have
to provide for themselves.  For the record I have not supplied the
rear motor mount for anyone and have no intention of doing so unless
it would be for a Tailwind or the RV-4 or 6 taildraggers.      Jerry
You would weld something if somebody gave you a drawing
of what they wanted ... right Jerry?


Sorry for the confusion, Jerry.  You've been dealing exclusively with
my build partner (also named Mark) who is off in Italy somewhere, and
not available.  Meanwhile, I'm trying to make progress at the hangar -
I'm not up to date on the FWF details, since that was 'his' bit to
worry about.  Thus my questions on whether this or that angle is
correct & what to do about the rear mount.

Mark [2]


Mark,  the engine mount was intended to have the engine centered on  the thrust line.  The engine's  pitch  can be controlled with the  rear strut.  If it is off from side to side then  you can shim the  mount at the firewall.    Jerry



The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.