Subject: Cato prop for sale.
From: Rotary Engine
Date: 8/1/2005, 12:29 PM
To: AA-me


http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll

     <http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll>?

ViewItem&item=4564632860
This prop belongs to a friend of mine and would be good for
people with
2.8
PSRU and 20B engine.
Bulent
Paul or Vance, would this prop work on the PPort 13B? T.W.
I suspect it would.
Vance? 275 HP at 7500 eng RPM
2600 prop RPM. Come to thing of it Tom vance is at OSH.
Paul Lamar

This sounds like a candidate for my p-ported 13b.  I'll take a
look at
at the listing when I get home tonight -- ebay is blocked here
at the
office.
Mark

Bulent-
Can you get the details on this prop?  Someone was kind enough to
email me a jpeg of the ebay listing & the prop is definately a
contender for what I need.  Now I need to nitty-gritty like
diameter,
pitch. hub hole spacing, etc.
Mark
Is'nt this prop set for reverse rotation, the 2.85:1 is normal
rotation I
think.

John

You think right. The prop is set for normal(Lycoming) rotation

     Craig Catto can plug the bolt holes and drill  new ones from  the
     opposite side to reverse rotation, which will work if you  are also
     going from pusher to tractor.   I have a Catto 3 blade also  intended
     for a Velocity that the 1O 360 200 hp engine could not  turn.  Strange
     this would come up twice.   Jerry
Oh, I didn't think about re-drilling the holes...  I did't  consider this
prop because the bolt holes were too big, but I could probably  have this
fixed by Craig...  Will give him a call.

Hold your horses guys. Think about it: If you use the same prop on a
tractor, the angle of attack will be right, but the trailing edge  will be
the leading edge. The airfoil will travel backwards.
Bulent
Lets narrow this down a bit. Standing in back of this prop mounted
on a pusher airplane power3ed by a Lycoming which way does it rotate?
Clockwise or counter clockwise?
If you move the prop to the front with out turning it around in a  vertical
axis it will still work (assuming the engine rotation is right)  but you
will have to redrill it as the counter bores for the drive  bushings will
now be on the front surface of the hub rather than the rear surface
of the hub.
Paul Lamar


Another thing: Catto props have aluminum plate bonded on the side  where it
meets the flange. The opposite side does not have that.
Bulent

No doubt about it. That certainly is a problem.

Paul Lamar

You can go from a pusher to a tractor if you are using the 2:17:1
drive.  Craig can reverse the holes and move the aluminum plate to
the opposite side.  Here is a pic of mine originally intended for a
Velocity.   Jerry



-- 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.