This is a very interesting web site and I want to thank
Gordon Arnaut for bringing it to my attention. Everybody on here
should read it.
http://www.epi-eng.com/
Jack apparently was involved with the ill fated big block Chevy
based Orenda V8 engine which failed after 30 years and 50 million
was dumped into it of mostly Canadian tax payers money.
Too bad the developers did not take Jack's advice :)
http://www.epi-eng.com/CNV-Primary.htm
"The installed weight of the proposed new powerplant is probably the most important
consideration in determining the suitability of a particular engine change program,
from the standpoints of (a) the flying characteristics of the aircraft, (b) the
engineering and testing required to obtain an STC and (c) the marketability of the
result. These considerations are especially critical in multi-engined aircraft which
have the engines cantilevered off the wings.
If the proposed new powerplant installation will be much heavier than the old one, no
matter how much more power it has, the effort is typically not justified. Please go
back and read that sentence again."
I wish I could afford the FEA software Jack uses to analyze motor mounts
and PSRU couplings or we had the money to hire Jack :)
I will add Jack's web site to the list of recommended web sites on
the ACRE NL web site.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.