Here are some better pictures of my engine stand adapter.

         The actual depth is 2.5 inches, not 3 inches as I estimated earlier.

         You can see the outer stiffening gusset quite well in these
pictures. There is a similar gusset on the other side of the web to stiffen
the flange that is bolted to the engine stand.

         Again, had I to do it over again, I would use 1/4 inch thick
angles instead of 1/8 inch thick angles.

         Bill Dube'


The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.