I have been reading the list trying to figure out what to go out and
look for. I have run into a few cheap 2nd gen motors, but that isn't
ideal.
The "I need to find" List:
2nd gen flex plate
Non P-Port engine spec:
3rd gen (materials improvements)
non-turbo (noise reduction)
manual (six port intake).
I'll need counter weights from automatic and a balancing job. (money)
Will the starter work from the manual engine on the auto flex plate?
Have to make my on intake system. Hard to align for good flow to
stock intake ports.
P-Port engine spec:
3rd gen (materials improvements)
non-turbo (noise reduction)
automatic (four port intake not used, smaller loss of water jacket
than six port)
Comes with stock counter weights balanced.
Slide throttle and intake. Easier to manufacture.
Computer is not readily available to run this engine. Tracy's ECU is not
setup to get accurate indication of O2 flow.
Blake
The third gen engines never existed in normally aspirated. One usually replaces the
rotors with high compression second gen rotors to run it NA. If this is for
the VW van don't mess with that. Not worth it. Post 1989 second gen engines
are fine. If for the airplane you will need the flex plate. If for the
VW van you are in luck. Flywheels are litter :) Also there has never
been a six port 3rd gen. At least in this country.
If you are going to mix and match for the aircraft get someone like
Mazdatrix to build it for you as they know all the combinations that work
together. They will also have it balanced as well as test run it on the
bench if not the dyno. They test run all their engines no charge.
The starter works for both TX and manual I think but I have seen two
types of starters and they are not interchangeable. You want the
one with solenoid off at about a 45 degree off the mounting bolt holes
and 12 teeth.
Tracy's computer will get accurate O2 flow on a p-port. Just tell him you
want to sample the intake chamber pressure on a p-port engine. He has agreed to
change the pressure sample timing in software as it will not affect the side port
pressure sample timing.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.