Big Snip

I think we have it figured out. Jerry assembled his and found
the problem.  Here is the solution. Find a tig welder
locally and send me the bill. My fault for not catching this.
Cheaper than shipping it back and fourth.

Paul Lamar

Paul, your drawing only shows the notches on one side but I sure you
want them on both sides.  The piece that is to be welded on just sits
on top of the S.beam I presume.  Is it the same for both sides?   Can
Rhino pop out a measured 2D drawing?    I will have to provide this
modification for all future S-beams and of course,  for those already
shipped.      Thanks, Jerry

They are there you just can't see them :)
See the last message.

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.