Subject: Spark plug fouling and lead scavenging.
From: Rotary Engine
Date: 8/8/2005, 9:08 PM
To: AA-me


 My biggest problem travelling is
finding mogas. I can't burn 100LL, it will foul my plugs every time.
Updates on http://www.ductedfan.com

Perry


Paul:

What steps can one take to be sure that he does not need to use mogas?
Don't want to be limited to only mogas.

Rick Irwin


The engine runs fine on 100LL. 100LL just slowly fouls the plugs and
slows the response time of the O2 sensor which is not a real problem

as

Tracy does not use the O2 sensor. Perhaps for initial tuning.

Run some auto fuel once and a while and the O2 sensor and maybe the
plugs will recover.

Paul Lamar




Seems like there should be an adaptable sparkplug design that would be
less susceptible to lead fouling.

As well, if you are able to lean properly, especially running lean of
peak
EGT, the fouling problem should be reduced - less total byproduct per
operating hour.

I also wonder if running a lead scavenger such as TCP would be viable in
a
rotary.  I know the lead scavengers can be only marginally effective on
engines that don't burn very hot (like the little Continentals) - (I
think) low EGT means the lead salts condense in the cylinder instead of
riding out through the exhaust.   I would guess that the rotary runs
plenty hot for the scavengers to do their job - esp when leaned
properly.

Additionally, I wonder if running two-stroke as pre-mix would be better
with the lead, instead of injecting crankcase oil like Perry's plane
does.
  Seems like any ash buildup from the crankcase oil would provide a
place
for lead deposits to form more easily.


Regards,

Matt-


Ah Matt you may have hit the nail on the head there. As far as I know
Perry is still using the stock 2nd gen computer system with no way of
manual leaning.
At least he did not have a way a couple of years ago. My RX8 engine with
the stock computer holds the mixture to .01 of stoichiometric.

Due to NOX emissions Mazda has little choice even though leaning
at 65 MPH cruising to 100 F EGT lean of peak would result in better MPG.

Paul Lamar



Perry told me last week that he didn't think TCP did the trick for him.
The plugs still fouled.

Rick Irwin

Here is the full story. I know my engine runs rich and I haven't
installed the circuit yet to trick the ECU to lean. So I burned mogas
from Oregon to KS and on the return trip back as far as Utah. Once I was
back in Utah I felt the worst terrain was behind me, Rocky Mountains
that is. I was only 4 hours from home and it takes about 4 hours of
burning 100LL before the fouling problem shows up. So I figured the
fouling would show up about the time I got back home, where I could deal
with it by swapping plugs and cleaning plugs. I also had bought some TCP
additive before the trip to experiment with. So starting in Utah I
loaded only 100LL and TCP. Because of heat and high density altitudes I
made two 2-hour hops with half-full tanks and had to stop in The Dalles
OR for a final 10 gals. to get me home. It was after takeoff from The
Dalles that the plug fouling showed itself - same as it always does, so
I knew immediately what was happening. It always shows up shortly after
takeoff, as a power loss. RPM dropped from 5400 to 4700. The leading
plugs are shorted out, and the engine is running on trailing plugs
only.The trailing plugs are more protected than the leadings since there
are only little holes in the rotor housings for the trailing plug spark
to enter the combustion chamber. For some reason, throttling back
slightly for 30 to 60 seconds, then slowly increasing power back to full
restores normal operation. So I entered downwind and did that. It
recovered and I circled  over the airport until I had significant
altitude and then resumed flight home, everything normal. Yesterday I
swapped out the plugs and diluted the remaining 10 gallons of 100LL in
the tanks with mogas before flying again.

This is probably not a problem for someone using Tracy's ECU or some
other that allows leaning in cruise. I've also learned now that TCP
doesn't work, so the only hope I have is to transplant the rich/lean
control I've built from my RX-7 to the Long-EZ.

I would like to see every EAA chapter around the country install a large
farm tank at their chapter meeting house to provide mogas. I suppose EPA
regs and local FBOs would keep such an idea from reaching reality. Where
is 82UL?

Perry

Perry since you are running the stock computer and ignition what
about an MSD system?

Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.