(snip)
Here is the full story. I know my engine runs rich and I haven't
installed the circuit yet to trick the ECU to lean. So I burned mogas
from Oregon to KS and on the return trip back as far as Utah. Once I was
back in Utah I felt the worst terrain was behind me, Rocky Mountains
that is. I was only 4 hours from home and it takes about 4 hours of
burning 100LL before the fouling problem shows up. So I figured the
fouling would show up about the time I got back home, where I could deal
with it by swapping plugs and cleaning plugs. I also had bought some TCP
additive before the trip to experiment with. So starting in Utah I
loaded only 100LL and TCP. Because of heat and high density altitudes I
made two 2-hour hops with half-full tanks and had to stop in The Dalles
OR for a final 10 gals. to get me home. It was after takeoff from The
Dalles that the plug fouling showed itself - same as it always does, so
I knew immediately what was happening. It always shows up shortly after
takeoff, as a power loss. RPM dropped from 5400 to 4700. The leading
plugs are shorted out, and the engine is running on trailing plugs
only.The trailing plugs are more protected than the leadings since there
are only little holes in the rotor housings for the trailing plug spark
to enter the combustion chamber. For some reason, throttling back
slightly for 30 to 60 seconds, then slowly increasing power back to full
restores normal operation. So I entered downwind and did that. It
recovered and I circled over the airport until I had significant
altitude and then resumed flight home, everything normal. Yesterday I
swapped out the plugs and diluted the remaining 10 gallons of 100LL in
the tanks with mogas before flying again.
This is probably not a problem for someone using Tracy's ECU or some
other that allows leaning in cruise. I've also learned now that TCP
doesn't work, so the only hope I have is to transplant the rich/lean
control I've built from my RX-7 to the Long-EZ.
I would like to see every EAA chapter around the country install a large
farm tank at their chapter meeting house to provide mogas. I suppose EPA
regs and local FBOs would keep such an idea from reaching reality. Where
is 82UL?
Perry
Perry since you are running the stock computer and ignition what
about an MSD system?
Paul Lamar
My 12a always ran great on Nippon Denso plugs and the MSD system with
100LL.... I had the white ash in the tailpipe after 100LL use, but the plugs
didn't foul out.... just got used up every 30 hours or so of flying (hard
flying gyroplane use) at 7500 rpms and "cruise" at 6500+ to 6800 typical. I
have a large bridgeport. I also admit to "cleaning" the engine with a water
pistol into the intake while running every few months.
Gary Buster N263GB (disassembled due to divorce!)
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.