Things like composite heat exchanger air ducts and intake runners
should have a smooth interior for minimum skin friction loss.
Smooth male molds are therefor called for. Also if one wraps or filament
winds the part in one piece one may also need this technique. Unfortunately
sometimes the male mold will get mechanically locked into the part.
We went around and around on this a few years ago on the best
way of making composite intake runners. We considered carving
them out of foam and dissolving the foam in acetone or lacquer
thinner. That works but one must carve a new male mold each
time one makes a new runner. One can also make a two piece
female mold over a male buck and fill it with expanding foam.
Remove the foam when it is cured and layup over that.
High production composite intake manifolds are made with metal male and
female molds and are injection molded. A very expensive process
for small scale production.
This is a technique I just learned from reading High Performance
Composites magazine.
www.compositesworld.com
The hollow mold is made in segments with joints arranged so
the male mold can be collapsed from within. Probably
more applicable if one is going into small scale production.
They can be Teflon taped on the outside to seal the joints
and hold the mold together.
Bernie Kerr came up with a trick of using a bicycle inner tubes
filled with sand to form a male mold. He claims it can be formed to
any shape and it will hold that shape. One might also try that for
intake runners.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.