> Hi folks,
> For anyone interested, I have about 28 - (2 x .049) Inconel 625 tube bends
> for
> anyone that is interested in building their own exhaust. These tubes can
be
> welded to Inconel 618, Stainless 321, Stainless 304 with Inconel filler
rod.
> These are incredibly strong and will withstand the heat of a rotary. The
radius
> is 2 " and it is flared on one end to make an expansion joint for the
> downtubes. The bends are $90 each. Please email me off the site if your
> interested in the bends or you have any questions. I will ship anywhere.
> Doug Mueller
> RX-6 13BT
> N900DM
> Boulder City, NV
> Doug Mueller
> RX-6 13BT
> N900DM
> Boulder City(61B),Nevada
Doug,
Do you or anyone on here have a rough cost on exhaust flanges.
I just got a laser-cut cost and couldn't believe their prices.
George
Hey George, I just laid out a 3/8 inch Inconel 625 plate 1 square foot. It cost $835
US for the plate. It came from Germany. I also had a water jet cut it out for $140
US. I do have access to make more but this route is not cheap but it is aircraft
quality. If I could get enough interest in the ACRE I will go and mass produce these
but this is obvious sticker shock when you see Inconel compared to Stainless or Mild
steel.
I am in Europe all this week so I will try to get to email when I can. Thanks,
Doug Mueller
RX-6 13BT
N900DM
Boulder City, Nevada.
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.