> Greg wrote:
> > Hello. I was advised to get involved here to possibly find out
what the
> > fuel consumption will ultimately be with Innodyn's turbines. I
> > understand this is a newletter for rotary, but a saleman for a
rotary
> > company said I'd find out some interesting things about
turbines via you
> > newletter.
> > Thank you, Greg Nus
> >
> > PS. I'm building an RV10 and am on the fence between a mistral
G-230TS
> > and innodyn 255.
Neither the turboprop, the Mistral nor an O-540 is going to change the
frontal area of your RV-10, so the only drag difference will be the
cooling drag through the cowl.
Paul is being generous concerning the fuel consumption of small gas
turbines. Don't forget that Honeywell (allied Signal, garret, air
research), Sundstrand, Pratt and Whitney Canada, Turbomeca, Allison,
Ipec, and probably a dozen others have been working on small, light,
efficent, long lasting, cheap gas turbines since the 40's. There have
been thousands of APU's built in this HP range, and their fuel burn is
universally horrible. Obviously these were built to a price and
efficiency was not the primary goal, but all these manufacturers have
poured billions into development of small gas turbines, and certainly
didn't neglect efficiency research.
Some new start up who comes along and claims to make a huge leap forward
is lying - plain and simple. The huge improvements in automotive
efficiency (seen by all countries except the states) since the eighties
have been driven by EFI, FEM, and quality control. The Gas Turbine was a
optimised to a far higher standard before the development of FEM tools
and Digital engine control, and therefore see a much smaller efficiency
benefit for the application of these technologies.
Below about 400HP, the gas turbine really suffers due to the nature of
it's continuous combustion. A Wankel is a far better choice.
Regards,
Mark.
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.