Subject: Light weight rotary installation
From: Rotary Engine
Date: 8/13/2005, 11:22 AM
To: AA-me


I do have a question though regarding a rotary installation. I'm currently
considering a two seat carbon fiber side by side pusher, that has a maximum
recommended all up engine weight of 285lbs, ie O-320 and power output of
150/160hp.
    So the question is could a twin rotor either 13B or Renesis, all up
weight installation, inc rads, starter, and alternator be achieved under
300lbs.
If not, what is the lightest practical weight it could be done.
Finally, what are some of the things one could do to make weight savings on
a rotary installation.
Many thanks,
Michael.
Australia.

Start with an RX8 engine. Lighter weight water pump.
You would have to place close attention to such things as intake manifold
weight(P-port is lighter), motor mount weight, size of the water rad and volume of the
coolant but yes I think under 300 pounds could be done. You might have
to machine a bit of weight out of Tracy's PSRU as well. Wood prop of course.

I think an O-320 firewall forward would be heaver than 300 pounds however.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.