Subject: exhaust cooling /velocity
From: Rotary Engine
Date: 8/17/2005, 7:49 AM
To: AA-me



     > Hey Paul! Do you remember Joe Schiferl's velocity and how loud it
    was when
     > it left
     > Oshkosh? Proving that you can kill people with sound good lord
    that was
     > loud. Even
     > when he was outta sight. I could clearly hear his airplane. Anyway I
     > thought that the
     > concept for cooling was interesting. but I was wondering if the
    shroud
     > that he had
     > behind his airplane where the exhaust exited out the back there!
    I was
     > wondering if
     > that whole thing couldn't be turned into some kind of muffler to
    get the
     > D.B's down a
     > bit. Here is the drawing of what I think it may look like.
     > may work on my Long ez.
     >
     > Tony
     >
     > No muffler. Just an augmenter. You can hear all rotaries miles
     > away as they have a unique sound.
     >
     > Paul Lamar

    I'm working at fabricating an augmenter [Ejector] similar to what
    Tony sketched out
    (see attached jpg).  I am considering placing some mineral wool or other
    sound deadning material in the augmenter side walls.  The
    exhaust/cooling
    air temperatures should be considerably less than a conventional
    muffler and
    the air stream velocities should also be reduced which gives the 'glass
    pack' a much better chance of serviving.
    D Johnson

    Good idea. Easy to do. Might work well.
    However that was a blank jpg file you attached.

    Paul Lamar

I think that's a good idea. I did it quite a few years ago to the open
exhaust on my VW gyro, I called it a "halo", It consisted of a very
light aluminium tube about 9" diameter about 2' long open at both ends
and lined with rock wool. It certainly took the edge off the exhaust
note. It would probably work well on the high frequency stuff from a
rotary. I think I had the exhaust pipe terminating  about 3" into the
halo.Air entering the front kept it all cool.

John Evans

It is interesting that you used aluminum.  I was wondering if the
temperatures would get low enough in the muffler/augmentor to use aluminum.
I would have to look up the article in Contact magazine where the author did
static testing of an augmentor and said that the augmentor was warm to the
touch but did not was not hot enough to burn.  I will probably build the
prototype out of galvanized sheet metal for static testing.  I suspect that
the mouth of the augmentor would have to be stainless steel because the
exhaust & cooliing air is not well mixed.  If the temperatures are low
enough for aluminum would there be other concerns such as corrosion form the
exhaust gas residual?

D Johnson

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Copyright 1998-2005 All world wide rights reserved.